IMG_0035a.jpg70 viewsClearance between firewall and rear of engine. We used a clear piece of plastic to check for obstructions so we can decide where to put fittings etc. 12/11/09 at 19:51DamoH: It removes any guess work from tube location etc. ...
|
|
IMG_0035a.jpg70 viewsClearance between firewall and rear of engine. We used a clear piece of plastic to check for obstructions so we can decide where to put fittings etc. 08/23/09 at 20:00Jerry: Like that idea of using the clear plexi for checki...
|
|
Toot_352.jpg243 views01/13/09 at 15:45steveo73: In the paint shop
|
|
Toot_343.jpg200 views01/13/09 at 15:44steveo73: Tail rigging almost done
|
|
Toot_330.jpg192 views01/13/09 at 15:44steveo73: Sheetmetal finished
|
|
Toot_306.jpg221 views01/13/09 at 15:43steveo73: Wiring engine compt
|
|
inward_cross_tubes.JPGinward end of cross tubes98 viewsIn this photo the .063 wrappers around the tube ends are fully welded. We also added .050 end caps at the streamline tube ends instead of heat bending the streamline to meet the cross tubes. I am sure either way would work fine.10/14/08 at 17:07TommyJ: I put caps on the streamline too. When I was buil...
|
|
leadingEdgeBow.jpg240 views10/24/06 at 15:09jgnunn: Is this the top wing? What spars are those?
|
|
|
|
|
